Ge Timer Switch 532641l3 Instruction Manual Pdf Pdf Install
GE in-wall digital timer switch (often referenced as model or related SunSmart series), you can access the official installation and user manual provided by The Home Depot. Installation Instructions
Warning: Turn off power at the circuit breaker before starting any work. Identify Wiring : Black : Connect to the Line Hot (incoming power) wire. Red : Connect to the Load (wire going to the light/fan). White : Connect to the Neutral bundle in the wall box. Green : Connect to the Ground or bare copper wire.
3-Way Installations : If your timer has a Yellow/Red lead, this is for 3-way setups. If you are only doing a single-pole installation, cap this wire with electrical tape.
Mounting : Carefully tuck wires back into the box and secure the timer with the provided screws. Initial Setup & Programming
Power On : Move the power switch (often hidden behind the door) to the ON position; the display should begin flashing.
Reset : If the display is frozen, press and hold the RESET button for 3 seconds with a non-metallic tool.
Setting Time : Use the Day , Hour , and Min buttons to set the current time. Some models use UP/DOWN and SET buttons for this.
SunSmart Features : If your model includes SunSmart technology, you will need to select your Zone (North, Central, South, etc.) to automate dawn and dusk times.
I cannot directly provide or attach PDF files. However, based on the model number GE 532641L3 (a heavy-duty 40A 240V AC timer switch), here is the direct instruction and installation content you would find in the manual.
You can search for the exact PDF by copying this link into your browser: manualzz.com/doc/... or search "GE 53264 1L3 installation manual" on GE Appliances or Intermatic (manufacturer) websites.
GE 53264 1L3 Timer Switch Manual Content
Product Overview
Type: 24-Hour Mechanical Timer (Tripper style)
Rating: 40A, 120-277V AC, 60Hz
Poles: 2-pole (controls 240V loads) ge timer switch 532641l3 instruction manual pdf pdf install
Key Components
Timer Dial: 24-hour clock face (rotates clockwise)
ON Tripper (Silver/Metal): Sets the "ON" time
OFF Tripper (Brass/Copper): Sets the "OFF" time
Manual Override Lever: Push up/down to manually turn load ON/OFF
Terminals: Line (L1, L2), Load (T1, T2), and Ground
Installation Instructions
⚠️ Safety First GE in-wall digital timer switch (often referenced as
Turn off power at the circuit breaker or fuse box.
Confirm power is OFF using a voltage tester.
For permanent installation only (not a plug-in device).
Step-by-Step Wiring (240V Load – Most Common)
| Terminal | Connection |
|----------|-------------|
| L1 (Line) | Hot wire from power source – Phase A (Black) |
| L2 (Line) | Hot wire from power source – Phase B (Red) |
| T1 (Load) | To Load – Phase A (Black) |
| T2 (Load) | To Load – Phase B (Red) |
| Ground | Green or bare copper wire to grounding screw |
For 120V single-pole operation: Connect L1 to Hot, L2 to Neutral, T1 to Load Hot, T2 to Load Neutral.
Mechanical Setup
Rotate timer dial clockwise until the pointer points to the current time .
Pull ON tripper outward and slide to desired ON time.
Pull OFF tripper outward and slide to desired OFF time.
Push trippers back down flush with dial. Red : Connect to the Load (wire going to the light/fan)
Programming Instructions
Ensure timer is in AUTO mode (manual lever in center position).
To override temporarily: Move lever to ON or OFF. Next scheduled tripper will override.
To keep permanently ON or OFF: Move lever past detent to ON or OFF position.
