Hp Ms7860 Ver 12 Motherboard Manual New |best| Jun 2026

: Supports 4th Generation Intel Core i3, i5, i7, and Pentium processors. : Two DDR3 slots supporting up to (1600 MHz). Form Factor : MicroATX (approx. 244 x 244 mm). Expansion Slots (1) PCI Express x16 (3.0). (3) PCI Express x1. Rear Ports

4x SATA ports (usually 2x SATA II and 2x SATA III). Networking: Integrated Gigabit LAN (Realtek RTL8151GH-CG). Audio: Realtek ALC221 High Definition Audio. Rear I/O Panel 1x VGA Port. 1x DVI Port. 2x USB 3.0 ports (blue). 4x USB 2.0 ports (black). 1x RJ-45 Gigabit LAN port. Audio Jacks (Line-in/Line-out/Microphone). Optional Serial/COM Port. 3. HP MS-7860 Ver 1.2 Motherboard Manual Highlights hp ms7860 ver 12 motherboard manual new

The MS-7860 Ver 1.2 relies on a fourth-generation Intel architecture, rendering it highly efficient for office production, retro gaming rigs, or low-cost home servers. Specification Micro-ATX (244mm x 244mm) Processor Socket Intel LGA 1150 Chipset Intel H81 Express Supported CPUs 4th Gen Intel Core i3, i5, i7, Pentium, and Celeron Memory Slots 2 × Dual-Channel DDR3 DIMM Max Memory Capacity Up to 16 GB DDR3 (1333 / 1600 MHz) Storage Interfaces 4 × SATA Ports (Supports SATA II / SATA III speeds) Expansion Slots 1 × PCIe 3.0 x16, 3 × PCIe x1 Audio Chipset Realtek ALC221 High Definition Audio Network (LAN) Realtek RTL8151GH-CG Gigabit Ethernet Power Connectivity : Supports 4th Generation Intel Core i3, i5,

Supports 4th Generation Intel Core i3, i5, i7, Pentium, and Celeron processors. Expansion and I/O 244 x 244 mm)

The "Ver 12" is critical. Earlier versions (Ver 1.0, Ver 2.1) had different front-panel pinouts and power configurations. Version 12 introduced support for 4th and 5th Gen Intel Core processors (LGA 1150), DDR3 memory enhancements, and revised USB 3.0 headers.

In the default configuration, Pins 8 and 10 act as a jumper or "dead short" (likely for a chassis tamper switch). When installing this motherboard in a standard case, you must cut the jumper loop on Pin 8 and 10 (removing the black jumper), otherwise the system may not power on or will behave erratically. For the Power Switch (Power SW), connect your case leads to Pin 5 and Pin 7 .