V2000-c Rfid Access Control User Manual -

To enter programming mode, you must use the Master Code. The factory default Master Code is . Entering and Exiting Admin Mode

Before beginning installation, ensure your electrical infrastructure matches the unit's operating requirements: 2,000 cards/PIN codes Operating Voltage: 12V DC ±10% Card Type: EM (ID) Card (125 kHz format) Reading Distance: 3–8 cm Current Draw: Lock Output Load: Max 3A Door Relay Time: Adjustable from 1 to 99 seconds V2000-c Rfid Access Control User Manual

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. To enter programming mode, you must use the Master Code

If the master code is lost, you may need to perform a factory reset by powering off the unit, holding the exit button, and powering it back on, then pressing the tamper switch three times. This link or copies made by others cannot be deleted

For further support, consult your distributor for hardware-level repairs. The V2000-c’s simplicity is its strength – there is no cloud to fail, no subscription fee, and no software to crash. Just security that works.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.